Follow these simple steps to manually reset your amana ptac unit.
Amana ptac heater reset.
And just back up on a pthp.
While holding the buttons turn the master switch back on.
The heat pump reverses cycle so heat is rejected into the room and removes heat from the outdoors both ptac and pthp have a heat strip.
If those two digits are 35 37 or 50 indicating 3 5 3 7 and 5 0 kw the unit might be subject to the cap and it is then necessary to look at the serial number.
Make sure that the ptac unit is plugged in but not powered on.
How to fix amana ptac when only cold work but heater dont work easy fix 5 minutes.
Press and hold the temperature up and down arrows and double tap the heat button.
For amana brand units the two digits immediately before those letters identify the heater s power in kw units.
Push and hold both the heat.
Turn off the master power switch under the control panel.
The back up heat strips changeover when the pthp unit can no longer keep up using just the refrigeration compression cycle.
Leave off for at least 5 seconds.
The amana heat pump as you have probably heard is one of the best pumps of the kind.
Follow these simple steps to manually reset your amana ptac unit.
The number 88 will appear on the display.
Carefully lift off the front plastic cover by lifting up and pulling toward you.
3 5 kw 3 7 kw and 5 0 kw amana brand units with serial numbers.
Leave off for at least 5 seconds.
Remove the front cover of the unit.
Turn off the master power switch under the control panel.
Push and hold both the heat and cool buttons.
If you get it for your personal use you will be perfectly satisfied.
Make sure the unit is plugged in.
To start the run test.
The electric heat strip is the heat source for a ptac.